A couple years ago we bought a tempurpedic Up bed. This is different from the fully adjustable base. I found out that the headboard attachments that tempurpedic sells is not compatible with the Up base. So we have the mattress and base on the floor. This creates a problem because there is a gap between the wall and the bed. How can I get a headboard attached to this base?
We tried placing the mattress and base on top of a bed with slats (specifically the Emerson bed from west elm) but it created a bed that was overall too high - I had to jump to get onto it!
Alternatively, any specific bed recommendations that are *very* low and would therefore accommodate the base plus mattress without raising the overall bed height by more than a couple inches?
Or, a frame I can buy that goes around the base+mattress while keeping the base+mattress on the ground?
Tempurpedic customer service has proven unhelpful ("you can just build a bed around it")
My main goal is to eliminate the gap between the wall and bed with a headboard, without raising the overall height of the bed more than a couple inches.